Show Me The Money Glow Mica Powder

Yellow-tinted White powder that glows a very bright green yellow. The glow in the photo was just gotten by a flashlight. 

INCI: Zinc Sulfide

CAS# 1314-98-3

Will be in little bag unless you purchase the jar below. Can also add spoon for extra cost.

**Due to the many variations in monitors and browsers, color samples may appear different on different monitors. I try to get the best possible photos I can in the best possible light available.

Our "Glow in the Dark" pigments are approved for cosmetics use. Not all glow pigments activate well and light up. We have chosen 3 so far that activate best. To activate them, expose them to light.

There is only one ingredient that is approved for use in glow pigments for makeup. The color additive luminescent zinc sulfide is zinc sulfide containing a copper activator (copper chloride).  The FDA has stringent standards as to how much copper chloride can be in the powder.  Glow in the dark zinc sulphide is generally at least 99.8% Zinc Sulphide and less than 0.02% Copper Chloride. It is the copper activator that make the zinc sulphide glow! Here is an example of the breakdown of  this pigment. The INCI for luminescent zinc sulphide is INCI: Luminescent Zinc Sulphide.

Per the US FDA:

c) Uses and restrictions. The color additive luminescent zinc sulfide may be safely used for coloring externally applied facial makeup preparations and nail polish included under 720.4(c)(7)(ix) and (c)(8)(v) of this chapter, respectively, to the following restrictions:

(1) The amount of luminescent zinc sulfide in facial makeup preparations shall not exceed 10 percent by weight of the final product.

(2) Facial makeup preparations containing luminescent zinc sulfide are intended for use only on limited, infrequent occasions, e.g., Halloween, and not for regular or daily use.

(d) Labeling requirements. (1) The label of the color additive and any mixtures prepared therefrom shall bear expiration dates for the sealed and open container (established through generally accepted stability testing methods), other information required by 70.25 of this chapter, and adequate directions to prepare a final product complying with the limitations prescribed in paragraph (c) of this section.

(2) The label of a facial makeup preparation containing the color additive shall bear, in addition to other information required by the law, the following statement conspicuously displayed:

Do not use in the area of the eye.

(e) Exemption from certification. Certification of this color additive is not necessary for the protection of the public health, and therefore batches thereof are exempt from the certification requirements of section 721(c) of the act.